Cubicon Single – benchy

We recently received a Cubicon Single and I wanted to document our journey with it and its suitability to elementary or primary school classrooms.

Here is a Verbatim PLA benchy with a bunch of paperclip/lace clips.

You can see some warping on the clips and some didn’t stick well enough – this was disappointing.

I tried to adjust the contrast of the benchy so you can see how it prints.

I think the quality is quite good, still some banding – not completely smooth.






Try Makers Empire for free!

Start learning 3D design in minutes. Make teaching design and technology fun and effective!

Name McName

Put the general bio here…

 Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

Put the Q&A stuff here…

What’s your favourite ipsum?Definitely lorem ipsum